The installation of a cartridge will stop the drip and return your faucet to like new condition.
How to video, installation Instructions.
Use a flashlight to look around under the sink so you dont miss small leaks.Disconnect the water supply tubes from the tailpieces on the faucet, using a basin wrench or channel-type pliers.Release the water and look under the sink for leaks around the drain.Test the temperature of the water or insert a thermometer in the water and read the temperature.Slip the rubber washer onto the pop-up body and drop the pop-up into the sink drain opening.The button on,the strap can be pushed into open and locks into place when released.Generally speaking, 105 degrees Fahrenheit is a suitable temperature for a shower.Turn the end of the faucet's stem clockwise with a pair of pliers to turn the water on as hot as it goes.
Checking for leaks is the final step of any faucet installation.
Tools and Materials You Will Need.
Before completely tightening the lock nuts with a basin wrench, check to make sure that the faucet is centered and straight.To install the pop-up lift rod, start by inserting it into the faucet opening.Under the sink, attach the perforated strap to the lift rod.Allow the water to run for at least a minute.Repair your leaky faucet with the Danco Cartridge for Aquasource/Glacier Bay Single-Handle Faucets.This is a good time to clean the sink and remove any old putty or hard water build-up.To mapinfo professional 8.5 patch install the drain assembly, first separate the pop-up drain components.